Sometimes it is necessary to control a light from two different places; for example, the top and bottom of a stairway. When wired correctly, the light can be turned on or off from either switch. This can be done with two (2) three-way switches. To control a light from more than two switches, use four-way switches. There are several ways to wire three-way switches to a fixture. This is the simplest way.
Instructions
-
- 1
Between the fixture and the first switch, run two-wire cable. Then, between the two switches, run three-wire cable.
- 2
The feed wire (from the power source) should be two-wire and will have a black wire and a white wire. Using a wire nut, attach the white wire from the feed to the white wire at the fixture.
- 3
The black wire from the feed will run straight through the fixture to the two-wire cable running between the fixture and the first switch. Using a wire nut, attach the black wire from the feed to the white wire of the two-wire cable running between the fixture and the first switch.
- 4
Using a wire nut, attach the black wire from the fixture to the black wire of the two-wire cable running between the fixture and the first switch.
- 5
Go to the first switch. The white wire coming from the fixture should be attached to the dark colored screw on the switch. It is a good idea to mark this screw with paint or a permanent marker to indicate that it is “hot”.
- 6
Take the red and white wires from the three-wire cable running between the two switches and attach them to the light colored screws on the first switch.
- 7
Attach the black wire coming from the fixture directly to the black wire running between the two switches with a wire nut. The black wire should not be attached to the first switch.
- 8
Go to the second switch. Attach the red and white wires to the light colored screws and the black wire to the dark screw.
- 9
Test your switches. You should be able to turn the fixture on or off from either switch.
- 1
Tips & Warnings
-
When stripping your wires, only strip the amount you need. Be sure you do not have bare wires touching each other. This can cause a short, which can result in a tripped breaker, blown fuse, or (worst case scenario) fire.
-
Always tape connections made with wire nuts to avoid bare wires contacting other bare wires.
-
BE SURE TO CUT THE POWER TO THE AREA BY TRIPPING THE BREAKER OR
-
PULLING THE FUSE BEFORE WORKING.
-
Always replace switch covers to avoid the risk of electric shock.